HP BL536A, User'S & Service Manual

Page: 22 / 165

Figure 9 Product components
2. Parallel SCSI or SAS interface cable (parallel SCSI and
SAS Autoloaders only) 1. Autoloader
4. Product documentation 3. SCSI terminator (parallel SCSI Autoloaders only)
6. Six support feet 5. Ethernet cable
7. HP OpenView Data Protector Express Single Server
Edition CD
Attaching the feet
If you plan to mount the Autoloader in a rack or in the optional Tabletop Conversion Cover, skip
this step and continue with
Removing the shipping lock (page 23) .
CAUTION: The Autoloader must be supported under both side edges to operate properly. If the
Autoloader is not mounted in a rack or in the tabletop conversion kit, you must apply the feet.
Do not put anything on top of the Autoloader. Weight on top of the Autoloader can prevent the
robotic inside from moving properly. If you must place items on top of the Autoloader, install it in
the optional tabletop conversion cover, which can support up to 15 kg (33 lb).
You need the six support feet from the accessory package for this procedure.
To attach the feet:
1.
Verify that there are no tape cartridges in the Autoloader.
IMPORTANT: The Autoloader may be damaged if it is turned over with tape cartridges in
the magazines or robot. If the Autoloader has been used before, use the manual magazine
release to remove the cartridges from the magazines (see
Using the manual release (page 134) .
2. With another person, gently turn the Autoloader over and set it on its back.
3. Locate the six inscribed foot location lines on the bottom of the Autoloader.
4. If the Autoloader is not new, clean the foot locations with a damp paper towel.
5. Peel the backing paper off each foot and apply it within a set of foot location lines (see
Attaching the feet to the bottom of the Autoloader (page 23) ).
6. With another person, gently turn the Autoloader over and set it on its feet.
22 Installing the Tape Autoloader