HP Aruba 7010 Series, Installation Manual, Page: 23 / 28

Aruba 7010 Series Controller
| Installation Guide Installation |
23
3. The 7010 controller is now turned Off.
Installing an SFP
To install an SFP module into the 7010:
1. Slide the SFP module, top side facing upward, into a 1000Base-X port until a connection is made
and an audible click is heard (see Figure 12 ).
Figure 12 Installing an SFP
Removing an SFP
To remove an SFP module:
1. Open and release the latch on the SFP module.
2. Pull and remove the module from the port.
Connecting an LC Fiber Optic Cable
To connect an LC fiber optic cable into an SFP-SX or SFP-LX module:
1. Clean the fiber optic cable connector before inserting it into the SFP module.
2. Insert the fiber optic cable into the SFP module. Ensure that the latch on the cable faces the top of
the SFP module (see Figure 13 ).
3. Slide the cable into place until a connection is made and an audible click is heard.
To disconnect an LC fiber optic cable from an SFP-SX or SFP-LX module:
1. Depress the transceiver handle to release the latch on the cable and simultaneously pull the cable
out of the port.
Use standard ESD precautions when installing or removing an SFP.