NOTE:
Not all transceivers support Digital Optical Monitoring. If DOM appears in the Diagnostic
Support field of the
show interfaces transceiver detail
command, or the
hpicfTransceiverMIB hpicfXcvrDiagnostics MIB object, DOM is supported for that transceiver.
Viewing information about transceivers (CLI)
Syntax:
show interfaces transceiver [port-list] [detail]
Displays information about the transceivers. If a port is specified, displays information for the transceiver in that
port.
[detail]
Displays detailed transceiver information.
MIB support
The hpicfTransceiver MIB is available for displaying transceiver information.
Viewing transceiver information
The transceiver information displayed depends on the
show
command executed.
The output for
show interfaces transceiver [
port-list
]
is shown below. You can specify multiple
ports, separated by commas, and the information for each transceiver will display.
Output for a specified transceiver
switch(config)# show interfaces transceiver 21
Transceiver Technical information:
Product Serial Part
Port Type Number Number Number
------- ----------- ------------ ------------------ ----------
21 1000SX J4858C MY050VM9WB 1990-3657
If there is no transceiver in the port specified in the command, the output displays as shown below.
Output when no transceiver is present in specified interface
switch(config)# show interfaces transceiver 22
No Transceiver found on interface 22
When no ports are specified, information for all transceivers found is displayed.
Output when no ports are specified
switch(config)# show interfaces transceiver
Transceiver Technical information:
Product Serial Part
Port Type Number Number Number
------- ----------- ------------ ------------------ ----------
480
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08
