HP apollo 4510 gen9, Setup And Installation Manual

Page: 21 / 68

Installing the chassis 21
Installing the chassis
Installation overview
To set up and install the chassis:
1.
Set up and install the rack. For more information, see the documentation that ships with the rack.
2.
Disassemble the chassis (" Disassembling the chassis " on page 21 ).
3.
Install the chassis into the rack (on page 25 ).
4.
Install the system components into the chassis (on page 28 ).
Disassembling the chassis
Before installing the chassis into the rack, you must remove the pluggable modules and system
components from the chassis. Because a fully populated chassis can weigh up to 99.79 kg (220.00 lb),
remove the components from the chassis to make moving and installing the chassis easier.
1.
With the chassis still on the pallet, remove all components from the front and rear of the chassis.
o
Power supplies