Removing and replacing the power supply blank
CAUTION:
For proper cooling, be sure that a component or a component blank is always installed in each bay
in the rear of the chassis. When replacing a component or blank, leave the bay empty for no more
that 60 seconds. Failure to do so can disrupt airflow in the chassis.
Procedure
Remove the component as indicated.
To replace the component, reverse the removal procedure.
Removing and replacing a drive
Procedure
1.
Determine the status of the drive from the
2.
Back up all data on the drive.
3. Extend the drive drawer from the chassis
on page 25.
IMPORTANT:
Label the drives before removing them. The drives must be returned to their original locations.
4.
Remove the drive.
34
Removing and replacing the power supply blank