Installing the Adapter
20
A6826A PCI-X Host Bus Adapter for Linux 64-bit Systems Installation Guide
LED Indicators
identifies and describes the activity of the LED indicators.
Jumpers
The jumpers on the HBA are set to the default state of the laser and are set at the
factory with a jumper plug on pins 1-2 of the J3 jumper and on pins 1-2 of the J4
jumper.
Caution:
Changing the jumper settings can result in the HBA being
inoperable.
Before You Begin Installation
The HBA is self-configuring. However, some motherboards require manual
configuration. See the documentation supplied with your computer, or contact
your computer dealer to determine if your motherboard requires configuration.
Table 4: LED Indicators Activity
Green LED
(2Gb)
Amber LED
(1Gb)
Comments
Activity
Off
Off
Power Off
On
On
Power On (before firmware
initialization)
1 Flash/s
1 Flash/s
Both flashing at the same
time like a heart beat.
Power ON (after firmware
initialization)
2 Flash/s
2 Flash/s
Alternate flashing. This
state changes to
not-initialized state in 2-3s.
Both LEDs are ON
steadily.
Firmware Fault
OFF
ON
1G Link UP
ON
OFF
2G Link UP
OFF
5 Flash/s
Activity at 1G
5 Flash/s
OFF
Activity at 2G
