15
Figure 17
Removal procedure
The installation and removal procedures for the PSR150-A and PSR150-D power supplies are the same.
This document uses the PSR150-A as an example.
Installing a power supply
CAUTION:
To prevent damage to the power supply or the connectors on the backplane, insert the power supply
gently. If you encounter a hard resistance while inserting the power supply, pull out the power supply and
insert it again.
To install a power supply:
1.
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well
grounded.
2.
If the power supply slot is covered by a filler panel, remove the filler panel first.
3.
Unpack the power supply and check that the power supply model is correct.
4.
Correctly orient the power supply with the power supply slot (use the letters on the power supply
faceplate for orientation), grasp the handle of the power supply with one hand and support its
bottom with the other, and slide the power supply slowly along the guide rails into the slot (see
callout 1 in
).
5.
Fasten the captive screws on the power supply with a Philips screwdriver to secure the power
supply in the chassis (see callout 2 in
). If the captive screw cannot be tightly fastened,
check the installation of the power supply.
NOTE:
If you install only one power supply, install the filler panel over the empty power supply slot for good
ventilation.
Figure 18
Installing a PSR150-A power supply
