1-6
HP 85325A Operating and Service Manual
Installation
Receiver Settings
7. Press:
[PRIOR MENU]
{POWER LEVELING}
{SOURCE 1: MM MODULE LEVELING}
NOTE
I
In some setups,
{SOURCE 1: MM MODULE LEVELING}
is not appropriate. Select
{SOURCE 1: INTERNAL}
if:
❍
Using an HP 8510B
❍
Using an HP 8510C with firmware Revision 6.1 or lower.
❍
The source interface cable is not connected to the HP 836xx.
❍
Using an HP 8340/41, and it is not connected as shown in
Appendix A.
8. Press:
{SOURCE 2: INTERNAL}
[PRIOR MENU]
{EDIT MULT. SRC.}
9. Press:
{DEFINE: SOURCE #1}
{MULTIPLIER NUMER.} [1] [x1]
10. Press
{MULTIPLIER DENOM.}
and do one of the following:
a.
If source 1 (the RF source) is an HP 836xx, and the source interface
cable is connected: press
[1] [x1]
b.
If source 1 is an HP 836xx and the source interface cable is not
connected, enter the DENOM. value for your band (shown in
Table 1-2), remember to terminate with
[x1]:
Table 1-2
DENOM Value Table
Band
DENOM Value
Start Freq (GHz)
Stop Freq (GHz)
R
2
26.5
40
Q
3
33
50
U
3
40
60
V
4
50
75
W
6
75
110
