HP 85106D, Manual

Page: 51 / 244

2-6 HP 85106D mm-Wave System
Operation
System Set Up
Procedure
The following procedure describes loading the network analyzer memory
from the system disk.
1. Load the desired Machine Dump file from the system. Insert the disk
into the internal drive of the HP 8510C external disk drive. Press the
following keys:
[
DISK
]
{
STORAGE IS INTERNAL
}
{
LOAD
}
{
MORE
}
{
MACHINE DUMP
}
Use the RPG knob to select the file for the desired frequency band
(see Table ).
Press: {
LOAD FILE
} to start the process.
Table 2-1 Machine Dump Files Stored On The mm-Wave System Disk
NOTE If your system contains an extra test set (HP 85106D Option 001), verify that
only the desired test set is active (active light ON). If unselected test sets are
active, deactivate the test set temporarily by pressing [
LOCAL
] {
TEST SET
}.
Then return to the desired address.
2. When the Machine Dump file is loaded the system begins sweeping the
full frequency range of the current band. Press [
CAL
] and read the
{
CAL 1
} label to see whether the calibration kit for the desired band is
loaded.
3. The system is ready for operation. You may change the instrument state
settings for specific applications.
Frequency
Range
45 MHz - 50 GHz 33 GHz -50 GHz 40 GHz -60 GHz 50 GHz -75 GHz 75 GHz -110 GHz
Frequency
Band
Coaxial
((option001)
Waveguide
Q-band
WR-22
U-band
WR-19
V-band
WR-15 W-band
WR-10
Machine
Dump Files MD_COAX MD_SYNWR22 MD_SYNWR19 MD_SYNWR15 MD_SYNWR10