HP 5243-2SE, Installation And User Manual

Page: 12 / 34

Installing and Configuring the Tape Drive for the
NonStop S-Series Server
5243-2SE Tape Drive Installation and User’s Guide — 542757-003
2 -2
Installation
3. Complete these steps first for the drive on the left side of the unit and then for the
tape drive on the right:
a. Connect one end of the SCSI cable to the corresponding SCSI port at the rear
of the tape drive. For the location, see Figure 2-2 and Figure 2-3 .
b. Hand tighten the screws to secure the cable to the unit.
c. Connect the opposite end of the SCSI cable to the NonStop S-series server.
The tape drive can connect to the
ServerNet/DA
,
IOMF2 CRU, or PMF
CRU
on the NonStop S-series server.
You can use any of the SCSI cables listed in Table 2-1 .
Note. The tape drive’s SCSI IDs come preconfigured to SCSI ID 5. If you need to change
the SCSI IDs, use a screwdriver. Do not use a lead pencil.
Figure 2-2. Rear View of Tape Drive
Table 2-1. SCSI Cables
Model Number Description
519-003W 3 meter copper SCSI cable
519-015W 15 meter copper SCSI cable
519-020W 20 meter copper SCSI cable
519-023W 23 meter copper SCSI cable
SCSI ID SCSI Ports Fan Power Connectors Fan SCSI Port SCSI ID