HP 425 Wireless Dual Radio 802.11n Access Point Quickstart
6
AP status LEDs
© Copyright 2013 Hewlett-Packard Development
Company, L.P. The information contained herein is
subject to change without notice.
September 2013
Printed in
Document part # 5998-4326
*5998-4326*
AP status LEDs
HP 425 optional antennas
Only the following antenna is approved for use with the AP:
Caution:
For external antennas only: Depending on the country of use and
your radio settings, it may be mandatory to reduce the radio transmission
power level to maintain regulatory compliance. For specific power limits for
your country, see the
HP 425 AP Antenna Power-Level Setting Guide
available
from www.hp.com/support/manuals. Search by antenna part number.
For important safety, environmental, and regulatory information, see also
Safety and Compliance Information for Server, Storage, Power, Networking,
and Rack Products
, available at:
www.hp.com/support/Safety-Compliance-EnterpriseProducts
LED color
State
Description
Green
Flashing
1 flash/sec.
The AP is booting.
Fading in/out
At least one client is connected to the 2.4
GHz radio.
Blue
Flashing
2 flashes/sec.
The AP is updating its system software
image.
Flashing
2 sec. on/
2 sec. off
The AP is booted and is registered to the
controller. There is no client connected.
Fading in/out
At least one client is connected to the 5 GHz
radio.
Orange
On for more
than 20 sec.
An initialization exception has occurred.
Flashing
1 flash/sec.
There is a problem with the radio module.
Flashing
2 flashes/sec.
Both radios are disabled or the Ethernet port
is disabled while no local mesh peer exists.
Green/Blue
Alternately
fading green
and blue
Clients are connected to both the 2.4 GHz
and 5 GHz radios.
Part
Type
Band
Gain
Use
Elements
JG696A
Omni-directional 2.4/5GHz 2.5/6dBi
Indoor
4