Interface Card installation
HP 82335 A/B
The A and B version of these 8 bit ISA bus cards differ only in the software that
was supplied with them.
The dip switch on the card should be set as follows:
This sets the address of the card to DC00 to DFFF
If the config.sys file contains an EMM386 statement the following should be
added:
DEVICE = EMM386.EXE X=DC00-DFFF
This to prevent memory conflict between the memory manager and the interface
card.
No drivers are required for the HP card, all the software is contained within the
program.
National Instruments GPIB II/IIA card
Set the dip switches as follows:
PC II
7210
A9 = 1
A8 = 0
A7 = 1
A6 = 1
A5 = 0
A4 = 0
A3 = 0
Jumper in the IRQ 5 position
No DMA Jumper
