Adjusting your new tricycle
22
Cushion features additional rigid mesh pad-
ding.
The ErgoMesh-seat for Scorpion /fx
/fs 20 /fs 26 /fs 26 Enduro
/fs 26 S-Pedelec /plus 20 /plus 26
The ErgoMesh seat is ergonomically shaped
and supports the natural S-curve of your
spine. Forces from pedalling are supported in
the area of your lower back just above your
hips (lumbar support).
Eight tension belts on the back side of the
seat allow the adjustment of the seat net to
your needs.
Does the seat feel too soft or gives you the
feeling of sitting on the seat frame, increase
the tension of the belts on the back side of
the seat.
Is it hard or uncomfortable, or do you feel
like slipping off when going through curves,
release the belts in the relating area.
It may be necessary to put a high force on the
belts to apply sufficient tension to the belts. If
it can not be done by hand, make use of a flat
nose pliers and pull the lose end of the belts
firmly. To easily loosen the belt, pull up the
round end of the strap retainer.
The angle of all ErgoMesh-seats can be adjust-
ed. Loosen the upper and the lower quick-
release lever – the middle lever should remain
closed.
Move the seat into the desired angle. Then
close the upper and lower quick-release lever,
regarding the sheets are completely covered
by the hole diameter of the clamping surface.
To adapt the tricycle perfectly to your needs,
we offer the following versions of the Er-
goMesh-Seat besides the standard version.
The ErgoMesh XL-versions
All ErgoMesh-seats are available as XL ver-
sion. These are 3 cm longer and 5 cm wider
than the standard versions. They are meant to
give strongly build persons a comfortable seat
option.
The ErgoMesh HS plus versions
The ErgoMesh HS plus seats have been de-
signed to simplify getting on and off the tricy-
cle. With a plus of 11 cm seat height
compared to the ErgoMesh-standard seats,
they give you a better overview in traffic.
ErgoMesh-seat standard (l.) and ErgoMesh HS (r.)
Attention!
When using the Er-
goMesh HS plus seats, be careful when rid-
ing through bends. Due to the increased
height the tricycle may tend to tip over
easily.
The Gekko fx 20, Gekko fx 26, and
Gekko 26 meshseat
The Gekko models are equipped with a mesh
seat which needs not to be removed for fold-
ing the tricycle. Using eight straps, the seat
surface can be adjusted individually to your
back. The backrest angle is fully adjustable
with a quick release. The seat is ergonomically
shaped and supports the natural S-curve of
