Optical Disc Drive
1.
Prepare the computer for disassembly (
Preparation for Disassembly on page 27
2.
Remove the access panel (
3.
Remove the front bezel (
)
4.
Lay the computer down on its side for greater stability.
5.
Disconnect the power and data cables from the back of the drive.
6.
Pull the latch away from the chassis then, slide the drive out the front of the chassis. The latch
secures the drive with a pin that locks into one of the screw holes on the side of the drive.
Figure 6-9
Removing the Optical Drive
To install a drive, reverse the removal procedure.
CAUTION:
Make sure that the power switch cables do not interfere with the installation of the optical
drive.
Removing the Card Reader
1.
Prepare the computer for disassembly (
Preparation for Disassembly on page 27
2.
Remove the access panel (
Drives
39
Summary of Contents for Compaq dx2290
Page 1: ...Service Reference Guide HP Compaq dx2290 Business PC ...
Page 4: ...iv About This Book ...
Page 8: ...viii ...