7.1.1 Switch off the supply pump at the mains.
7.1.2 Switch off E at the mains.
7.1.3 Remove the top cover / viewing hatch by
removing the four screws (Fig 13).
7.1.4 Pull off the lamp terminals (Fig 14 y). Slide
out the lamp (Fig 14). Dispose of the old lamp
according to local regulations.
7.1.5 Slide in the replacement lamp and push the
lamp terminals onto both ends of the UVC lamp.
7.1.6 Refit the top cover / viewing hatch and replace
the four screws. The lamp will not work unless
the top cover is screwed down.
7.1.7 Switch the supply to the E on and
check that the UVC lamp is working.
7.1.8 Restart the supply pump.
7.2 Care of the quartz tube.
Especially in hard water areas the quartz tube
sheathing the UVC lamp may become covered in
lime scale. This will reduce the efficiency of the
unit if it is allowed to build up. To clean, follow
the below procedure.
7.2.1 Switch off the supply pump at the mains.
7.2.2 Switch off E at the mains.
7.2.3 Remove the top cover / viewing hatch by
removing the four screws (Fig 13).
7.2.4 Remove the lamp as described above in 7.1.
7.2.5 Unscrew the two YELLOW compression nuts at
each end of the UV housing and place to one
side (Fig 15).
7.2.6 Slide out the quartz tube (Fig 16).
7.2.7 Wipe the outside of the quartz tube with a soft
cloth moistened with a gentle cleaning agent
(e.g. vinegar and water).
7.2.8 Inspect the quartz tube for any damage. If the
quartz is cracked or damaged in any way, it
should be disposed of and a new one fitted.
7.2.9 Slide the quartz tube back into the UVC unit.
Reattach one of the yellow compression nuts
loosely. Do not screw down.
7.2.10 Reattach the other yellow compression nut.
Screw both compression nuts down at the same
time. The quartz tube will align itself in the
correct position. Screw down each nut until the
stop on each yellow compression nut hits the
stop on the UV shroud. The line on the nut will
line up with the arrow on the UV Shroud. Do not
attempt to screw the yellow compression nuts
beyond the stop position (Fig 17).
7.2.11 Refit the lamp as described above in 7.1.
7.2.12 Refit the top cover / viewing hatch and replace
the four screws. The lamp will not work unless
the top cover is screwed down.
7.2.13 Restart the supply pump checking for leaks.
7.2.14 Switch the supply to the E on.
Winter Storage
When not in use, the unit should be removed,
thoroughly washed and cleaned, dried and stored in a
dry frost protected area. Always store the unit with the
lid off to ensure adequate ventilation and drying.
Contact/Spare Parts
For product advice and spares please contact
Hozelock Cyprio Consumer Services on 0121 313 1122
or visit www.hozelock.com
Hozelock Cyprio Clearwater Guarantee
WE GUARANTEE YOU CLEAR WATER OR YOUR
MONEY BACK for a Hozelock Cyprio E when
used with the appropriate pump.
NOTE: IN SOME CASES IT CAN TAKE UP TO 8
WEEKS FOR YOUR WATER TO BECOME CLEAR.
This guarantee runs for 12 months after purchase,
provided that
• You have followed the installation and operating
instructions.
• You are using equipment of the correct size and
stocking level according to Hozelock Cyprio’s sizing
information.
• You consult our Helpline (0121 313 1122) early
enough for any problems to be put right.
• The product has been returned undamaged.
A refund can only be authorised by Hozelock Cyprio
and is made only at the place of purchase to the value
of the purchase price of the E only. A Proof
of Purchase will be required. Please note that the
Clearwater Guarantee does not cover loss of water
clarity when blanketweed, as opposed to greenwater
algae, is the cause.
2 Year Product Guarantee
If this E (excluding lamp) becomes
unserviceable within 2 years of the date of purchase
it will be repaired or replaced at our option free of
charge, unless in our opinion it has been damaged.
Liability is not accepted for damage due to accident,
improper installation or use. Liability is limited to
replacement of the faulty unit. This guarantee is
not transferable. It does not affect your statutory
rights. To obtain the benefits of this guarantee, firstly
contact Hozelock Cyprio Consumer Services (0121
313 1122) who may request that the unit is sent along
with proof of purchase directly to the address below.
Hozelock Cyprio Consumer Services on 0121 313 1122
or visit www.hozelock.com
