４
Operation
Bring the tip of the HC-31 close to the
area where color distortion was occurred
on the cathode ray tube. While pushing
the power switch, gradually pull the HC-31
away from the screen, and release the
switch when the distortion stops.
Repeat the operation or orient the HC-31
parallel with the tube face.
２
１
Plug in the power plug to the wall outlet.
●
For cathode ray tube
The same procedure as TV tube.
19.05
If your PC monitor is by aperture-mask system,
after finishing this procedure, sometimes verti-
cal lines appear on the screen by distortion on
aperture-musk itself receiving repercussion of
the demagnetizer, but this is not malfunction. In
case of this, softly hit the side of the monitor set
to recover.
Caution
Bring the tip of the HC-31 close to the magnetized object. While pushing the pow-
er switch, gradually pull the HC-31 away from the object approximately 30cm, and
release the switch.
●
For other
object
1-2-12 Saiwaicho, Naniwa-ku, Osaka 556-0021, Japan
Tel : +81-6-6567-3111
Fa x : +81-6-6562-0024
