Hook and loop
fasteners
Attach the hook and loop fasteners
to the
top of the table and the black side of the
rubber mat so that they can stick
together.
１
Loosen the holder set knob and remove
the holder. Then, remove the clips.
Finally, insert the rubber mat through the
post with the green side up.
３
ESD rubber mat
Table
Clips
４
４
Preparation
Procedures in case of using the ESD rubber mat
The provided rubber mat is a static controlled ESD rubber mat. Use it with
grounding when inspecting electronic components which are sensitive to static
electricity. Refer to page 8 regarding ESD measures.
Mount the holder on the post.
After this procedure, refer to
2
-
5
of
“Procedures in case of not using the ESD
rubber mat” on pages 3.
５
２
Settle the table accompanied by the post
and the holder on an appropriate place.
Also the stage should be set on the
table.
Grounding
Ground cord
Insert the alligator clip into the insulation
cover for protection of electric shock.
Then, attach the socket of the ground cord
to the stud of the rubber mat behind the
post. Finally, connect the insulated*
alligator clip to the ground.
*Cut the cover to the proper length as
needed.
