３
Preparation
２
Remove
the
cap
from
the
objectives
and
attach
the
lens
filter
accompa-
nied
by
the
adapt
ring
.
４
Mount the holder at the low end on the
post.
Turn toward the front, then securely
tighten
the holder set knob.
３
Mount the head.
Turn toward the front and secure the
head set screw into any female screws,
right, left or front.
Remove the caps from the barrels.
Then, loosen the eyepiece set screws
and insert the eyepieces into the bar-
rels.
Drive the eyepiece set screws gently
so that the eyepieces stay and the
setting dot [
・
] of them, refer to the
photo, point at the zenith.
５
Please use eyecups (long) if necessary.
< How to attach the eyecup (long) >
1. Remove the eyecup (short) .
2. Attach the eyecup (long) as sown
in the illustration.
Choose to suit
Eyecup (short)
・
for persons in spectacles
Eyecup (long)
・
for persons in contact lenses or without spectacles
Bringing inspector’s cheekbones at eyecups (long) stables his/her eye
points.
・
for blocking the slanting rays
Engage the
projection with
the groove.
Eyepiece
Eyecup (long)
Setting dot
Eyepiece
Eyecup (short)
Eyepiece set screw
Holder set knob
Head set
screw
Lens filter with
adapt ring
Objectives
