Operation
４
Bring the tip of the HC-33 close to the
area where color distortion was occurred
on the cathode ray tube. Once push and
release the power switch. The power
damping function will work and off the
power in a second.
Repeat the operation or orient the HC-33
parallel with the tube face.
２
１
Plug in the power plug to the wall outlet.
●
For cathode ray tube
The same procedure as TV tube.
10.02C
If your PC monitor is by aperture-mask system,
after finishing this procedure, sometimes verti-
cal lines appear on the screen by distortion on
aperture-musk itself receiving repercussion of
the demagnetizer, but this is not malfunction. In
case of this, softly hit the side of the monitor set
to recover.
Caution
Bring the tip of the HC-33 close to the magnetized object. Once push and release
the power switch.
It can not be demagnetized enough when used against a tool or a little part. In
case of this, close the HC-33 and the object as near as possible, then while push-
ing the power switch, gradually pull the HC-33 away from the object approximately
30cm, and release the switch.
●
For other objects
1-2-12 Saiwaicho, Naniwa-ku, Osaka 556-0021, Japan
Tel : +81-6-6567-3111
Fa x : +81-6-6562-0024