Hoyt 2660CL, Instruction Manual

Page: 12 / 16

(11) PEAK Button
The PEAK mode is used to measure the peak
value of a signal. It is useable with AC Current
measurements. Press the PEAK button, the PMAX
annunciator turns on, and the display shows the
maximum peak value. When the PEAK button is
pressed again (less than one second), the PMIN
annunciator turns on, PMAX annunciator turns off
and the display shows the minimum peak value.
When the PEAK button is pressed for the third
time (less than one second), the PMAX and PMIN
PMIN annunciators are blinking, and display
shows current input value. The meter returns to
normal operation if the PEAK button is pressed
and held for longer than one second.
(12) SELECT Button
If SELECT button pressed in ACV or ACA
measurement mode, the meter enters frequency
counter mode with automatic range selection.
Therefore, pressing RANGE button in VAHZ mode
doesn't change the frequency range. However,
range changes the sensitivity of frequency
detection.
If the input signal has a small amplitude, the user
shall increase the sensitivity.
If SELECT button pressed in Ω measurement
mode, the meter exchange to Continuity Check &
Diode Measurement selection.
If press this key in these function circulation.
- 11 -