hoxter ECKA 35, User Manual, Page: 13 / 20

13
2. Open the door of the fireplace and on the bottom of the chamber place the dose of fuel
recommended for your type of the fireplace insert against the rear wall (Chapter 2.5) .
First place the larger pieces of wood, then smaller pieces (Fig. 7a) .
3. Place into the upper part of inserted wood (Fig. 7b) , between the small pieces of wood,
the stated ignition piece then ignite it.
4. Close the door and observe the fire until it is fully burning.
5. If the file is burned and the whole dose of fuel is burning, set the regulation of the air supply into
the central position (Fig. 8) to achieve the optimal output (Chapter 2.5) . If the burning did not
start, repeat the step No. 4.
FiG. 8
6. If it is not necessary, do not open the door of the fireplace and do not interfere with the burning
Leave the dose of the fuel to burn out. Add the next dose in the heat phase (active burning with
flames terminated). Slowly open the door to prevent the escape of smoke into the room and add
the dose of the fuel to your fireplace
(Chapter 2.5) .
7. If you do not want to add more fuel and the dose has burnt out, set the regulation of air to
the left to the minimum ( Fig. 9 ). This will prevent burning air getting into the chamber and will
prolong the heat phase. The coal will remain hot in the chamber longer and the heat will not
escape through the chimney.
FiG. 9
FiG. 7a FiG. 7b