Once shaker panelling is fitted, fit architrave/dado rail
onto the top edge.
Note:
Shaker panels are 12mm in thickness. This may mean they will stand proud of skirting/architrave.
To overcome this issue, skirting/architrave can be packed out away from the wall.
Alternatively, chamfer the joining edge of the wall panel.
Architrave/Dado mitred
before fitting
Cut panelling around plug sockets
measuring the appropriate hole. Face
plates should be removed and surface
mounted.
Note:
Electrical supply should be
turned off before removing face plate.
9
10
5
6
7
8
HD715081
Each pack of shaker wall panelling is supplied with an end stile.
‘X’
Measure the distance between the cross rail on the last panel
fitted and the wall/end of the run.
Fit the cut-down panel to the wall and then fit the end stile.
Note:
The end stile will require packing out by 6mm
(spare
anchor points can be used for this).
Note:
One end stile is supplied per pack of 5 panels. If the
room layout dictates that additional ends stiles are required,
these can be cut from spare panels.
To finish a corner (internal or external angle), decorators
caulk can be used to fill the joint. Alternatively, use a
quadrant or corner profiles to finish.
Note:
On an external angle, the
panelling edge will protrude the wall
by 6mm to enable the external angle
to be created.
Shaker wall panelling can be painted.
Follow the paint manufacturers guidelines
for paint application.
Note:
Lightly sand the panel and wipe
clean before painting.
Decorators caulk can be used to fill any
slight gaps in the joints caused by the
contours of the wall.
Internal angle
2mm
Chamfer
6mm
Packing
End
Stile
Cut the panel to the width required making sure 100mm is
deducted from the measurement ‘X’ for the end stile.
Note:
Add a 2mm chamfer to the end of the top/bottom rail on
the cut panel to create a ‘V’ groove.
(‘X’ - 100mm)
Quadrant profile
MOD0081/92/0710
External angle
Corner profile
MOD0083/0712
6mm
Packer
required
6mm
Brush or Roller
Paint