INSTALLATION INSTRUCTIONS
VL Series
Howard Lighting Products | 580 Eastview Drive | Laurel, MS 39443
(toll free) 800.956.3456 | (direct) 601.422.0033
www.HowardLightingProducts.com
Page
2
of
2
Rev:
11/7/2017
3.
Tighten threaded coin plugs.
Fig. 3(a)
Fig. 3(b)
Fig. 3(c)
4.
Orient so that the UP (↑) arrow points upwards (figure 3(a)). Secure the back plate to junction box
by screws (provided by others).
5.
Apply silicone glue (provided by others) along the top and down both sides to prevent water
entering the back of the fixture.
See figure 3(b) & 3(c).
6.
Hang the fixture on the back plate. Connect the green ground wire with ring terminal to the back
plate (figure 4(a) & 4(b)). Using wire-nuts (provided by others) connect white to “Neutral”, black to
“Live”, and green to “Ground”.
FIG. 4(a)
FIG. 4(b)
FIG. 5
7.
Close fixture and tighten the 2 screws (figure 5).
8.
Adjust fixture to desired angle.
WARNING –
Water entering the fixture is likely to cause failure. Water damage due to loose coin plugs or
failure to seal the perimeter of the fixture to the mounting surface or failure to remove weep-
hole screws will void warranty.
FIG.2
