1025-001011-998 RV-A
V-CLIP HANGER ACCESSORY:
MHB Series High Bay luminaries are designed for easy mounting when used with
HF-2CV and HF-3CV Chain Hanging Accessory Kits (sold separately). Not recommended for use with 480V/AX models.
Typical HF-#CV kit contents shown.
Secure chains to mounting support
(using S-Hooks if necessary).
After attaching V-Clip to Chain, insert
V-Clip into slotted holes as shown.
Repeat for opposite end of fixture.
Pivot V-Clip to vertical so that clip
ends come up through adjoining
slotted holes.
CABLE HANGER ACCESSORY
:
MHB Series High Bay luminaries are designed for easy mounting when used with HF-
WCH series Wire-Cable Hanging Kits.
Typical HF-WCH kit contents shown.
Secure cables to mounting support (as
detailed with kit instructions).
Insert cable ball and toggle into
desired slot as shown.
Repeat as necessary to support fixture
on each end.
J-BOX ACCESSORY
:
MHB Series High Bay luminaries are designed for easy J-Box installation when ordered with J-Box
option.
Secure J-Box to rigid conduit using
supplied conduit nuts.
Slide MHB Fixture tabs onto J-Box as
shown and secure with (2) supplied
screws.
Make input wiring connections
(typical), and install supplied J-Box
cover.
Secure cover with supplied screw.
TROUBLESHOOTING TIPS:
If the fixture fails to operate properly, check the following:
Verify proper line voltage is present.
Verify input wiring connections to power source.
Verify that the fixture is grounded.
WARNING:
These procedures should only be performed by a qualified electrician. Supply power should be
turned off when replacing components or checking connections. Never perform maintenance or cleaning
while fixture is energized. Disconnect power and allow to cool before servicing.
