WARNING
Any Eagle that does not work properly
can cause you to lose control and fall.
Inspect the entire device thoroughly
before every ride, and do not ride it until
any problems have been corrected.
CHARGING THE DEVICE
• Ensure that the charging port is clean and dry.
• Make sure that there is no dust, debris or dirt inside the port.
• Plug the charger into a grounded wall outlet.
• Connect the cable with the power supply (100V ~ 240V; 50/60 Hz).
• Align and connect the 1-pin charging cable into the charging
port of the Eagle Scooter.
(DO NOT FORCE OR BEND THE CHARGING CABLE AS IT MAY
CAUSE THE PRONGS TO BEND OR BREAK.)
• The charging indicator light on the charger itself should change to
RED, indicating that your device is now being charged.
• When the RED indicator light on your charger turns to GREEN, then
your device is fully charged.
• After fully charging your Eagle Scooter, unplug the charger from
your device and from the power outlet.
• Power off your Eagle Scooter when charging.
Only use the included charging cable and
charger to charge your Hover-1 Eagle. Using
any other unauthorized charger may damage
your Hover-1 Eagle.
CAUTION
CHARGING YOUR EAGLE
Displays your current speed in Km/h.
Press 3 times constantly to switch
between Mph and Km/h.
Displays the current speed Level:
Ensure it is powered on, press once to
switch high speed / low speed mode:
P1 - Low speed mode
P2- High speed mode
Under Low speed mode, the max speed is
12km/h(7mph), Under High speed mode,
the max speed is 24km/h(15mph).
18
