4 213 321 V01 KDT RegelModul Solar EN.docx
32 / 95
Parameters
Designation
Value
Min.
Max.
Comments
R
W
20-009
Software version
expansion module 2
0
0
Software version expansion module 2 0 7
20-019
HW version expansion
module 2
0
0
HW version expansion module 2
0 7
20-200
Version_VMLib
1.3.0
0
0
Library version
5 7
20-201
Version_L2Lib
1.3.0
0
0
Library version
5 7
20-202
Version_BSPLib
1.3.0
0
0
Library version
5 7
20-203
Version_CommonLib
1.3.0
0
0
Library version
5 7
21-101
AFG1 system fresh air
sensor 1
--- °C
0.0
0.0
System fresh air sensor 1 (AFG1, of
BUS)
0 7
02-067
SO/WI display
0
0
1
Summer/winter operation display
4 7
11.3. Function name
In the Function name menu, it is possible to assign a freely definable name in addition to the standard
name of each function. This is then transferred to the operator level (e.g. for operating mode selection).
Both names are displayed in the parameter level.
11.4. Parameter overview general function name
Parameters
Designation
Value
Min.
Max.
Comments
R
W
04-005
Function name
General
13
0
Function as in a HVAC function, e.g. heating circuit
control, process water heating
0 5
11.5. Configuration
In the Configuration menu, the particular required hydraulic application can be selected, controller can
be reset to the factory settings, and a reference value increase or reduction can be activated.
11.5.1. Commands
The following commands can be carried out in the General
– Configuration – Commands (par. 04-045) menu:
0 :
No action
29 :
Error unlocking (not used at present)
31 :
Factory reset (reset the controller to factory setting)
Additional info: If the hydraulic application is adjusted on the controller, all parameters are reset to their factory
setting.
