7
1. Disconnect power source.
2. Lay drill on its side with feed wheel up to be sure
arbor clears table if unit is in normal operating position.
3. Turn feed handles until cutter mounting set screws are
exposed and then completely remove the set screws.
4. Insert proper pilot into shank end of the cutter.
5. Insert the Cutter until fl ats on cutter shank are
aligned with set screw holes and is exactly perpendicular
to the axis of set screw hole.
6. Insert Set Screws and tighten.
Pilot
40222 Set
Screws go here
"12000-Series"
Hougen Cutter
INSTALLING HOUGEN
CUTTER IN ARBOR
