Hottek HT-962-038, User Manual

Page: 11 / 20

ENG
11
Time setup
• Press and hold the «Time» button (5) until the hour indications on the
display (6) start flashing.
Notes:
When you install or replace the battery, the time «АМ12:00» will be shownon
the display and the hours indications will start flashing.
If you don’t press any buttons within 10 seconds, the indications on the display
will be shown constantly.
• Consequently press the button «Time» to set the desired hours. To enter the
hours indications press the button « | T». After you enter the hours data, the
minutes indications will start flashing.
Note:
This model uses 12 hour format of current time indication. When you set the
desired time, pay attention to the symbols «АМ/PM» alternately appearing in
the left part of the display. «АМ» indicates time before noon, «PM» – after
noon.
• Consequently press the button «Time» to set the desired minutes. To enter
the minutes indications press the button « | T». Time setup is finished.
Temperature indication
If there is a battery in the battery compartment, the temperature indication
is permanently shown on the display (6) regardless of whether the scale is
switched on or not.
Temperature measurement unit selection button
Room temperature is shown on the display (6) either in degree Celsius (°С) or
in degree Fahrenheit (°F).
You can change the temperature measurement units only when the scale is
switched on.
For this switch the scale on by touching the « | T» button and then touch and
hold the « | T» button for more than 4 seconds.
Note:
When you install or replace the battery, the temperature measurement units
«°С» are used (by default).
Replacement of battery
• Open the battery compartment cover and remove the safety film wrapped
around batteries. Install 1 battery of «CR2032» type strictly observing the
polarity, then close the battery compartment cover.