8.917-986.0 • DBA • Rev. 12/10
OPERATOR’S MANUAL
PRESSURE WASHER
8
STEP 1:
Insert rotary joints into
handle and frame tubes so that
stops point away from engine. Then
fi x them using 1/4" bolts and nuts on
each side and tighten.
STEP 2:
Attach the handle to the
frame. Align holes, insert one 3/8"
bolt and tighten the knob on each
side. Adjust handle at the desired
position.
STEP 3:
Use the carriage bolts to
attach the wand holder.
STEP 5:
Attach the high pressure
hose to the spray gun using tefl on
tape on hose threads.
STEP 8:
Release the coupler collar
and push the nozzle until the collar
clicks. Pull the nozzle to make sure
it is seated properly.
STEP 9:
Connect the high pres-
sure hose to the discharge nipple.
Push coupler collar forward until
secure.
STEP 6:
Attach wand to spray gun
using tefl on tape on wand threads.
STEP 7:
Pull spring-loaded collar
of the wand coupler back to insert
your choice of pressure nozzle.
STEP 10:
Connect garden hose to
the cold water source.
ASSEMBLY INSTRUCTIONS
STEP 11:
Check inlets filters,
remove debris, then connect the
garden hose to pump water inlet.
CAUTION: Do not run the pump
without water or pump damage
will result.
Rotary
Tube-Joint
Handle
Nut
Nut
Bolt
Bolt
Frame
Assy.
Knob
Gun
Holder
Safety
Latch
Spray
Gun
High
Pressure Hose
Wand
Spray
Gun/Wand
Wand
Coupler
Pressure
Nozzle
Pressure
Nozzle
Wand
Coupler
Coupler
Collar
Discharge
Nipple
High
Pressure
Hose
Cold
Water
Source
Garden
Hose
Pump
Water Inlet
Garden
Hose
Coupler Collar
Bolt
STEP 4:
Use the 5/16" x 1" hex head
bolt to attach the hose hanger.
Hose
Hanger
Nut
Washer
Bolt
Summary of Contents for DBA-252739
Page 17: ......
Page 19: ...Form 8 917 986 0 DBA Revised 12 10 Printed in U S A or Mexico ...