6.
TEACHING
7.
REPLACE FILTER COVER
TEACHING
”
is necessary so that the sensor can learn the distance from
the sensor to the floor.
1/ Clear the detection area
2/ Press the “Push SW” switch for 2s or more
3/ GREEN & RED LED flashes slowly for 10s, followed by
faster frequency flashes indicating that TEACHING is been
executed (If during this time, a person or object is in the
detection area, try again from STEP 1.)
4/ Green LED flashes once to indicate that the TEACHING
process is complete
5/ Verify the detection area for conformity to local regulations
Install the Filter Cover
1/ First fit the upper side of the Filter Cover into the full
length of the Aluminum Case.
2/ Slightly bend the Filter Cover at one end to latch it onto
the bottom lip of the Aluminum Case.
3/ Slide your hand along the bottom lip to lock the Filter
Cover in place
Attach the Joint
1
2
3
Snap the Joint into
Aluminum Case.
Slide the Joint so that it fits
snugly into the Filter Cover.
Attach remaining Filter Cover as
illustrated
Cut out the Side Cover wiring point and
insert the Wire Sheath into it.
Attach the Side Cover with
Screws provided.
Screw
After the Filter Cover is fitted, confirm that the detection range is as expected
and conforms with local regulations.
Check that the detection area conforms to EN16005
EN16005
8.
FINAL DETCTION RANGE CHECK
5
゜
1.
(1)Lift
(2)Slide
2.
(3)Rotate PCB unit
3.
(4)Slide Back
25
゜
4.
DETECTION ANGLE ADJUSTMENT
5
゜
25
゜
20
゜
15
゜
10
゜
Side View
5.
LED
Standby:
GREEN LED ON
Detecting:
RED LED ON
Environmental Error:
Fast alternate RED/GREEN LED followed by 1
flash of RED LED. If this happens execute the TEACH
function again with a white sheet of paper on the ground.
Internal Sensor Failure:
Fast alternate RED/GREEN LED followed by 3
flashes of the RED LED
The detection angle can be adjusted between 5 - 25 [deg] in 5 [deg] increments using
the Angle Stabilizer.
SSS-5: Quick Installation Guide
For a more detailed explanation on how to install the SSS-5 sensor please see the full installation instructions on our website at;
https://hotron.com/wp-content/uploads/2020/09/mp-10193_04_d201911271.pdf
