background image

11

GB

7

4

Sorting laundry

• 

Check the symbols on the care labels of the various 

garments to verify whether the garments can be safely 

tumble dried.

• Sort laundry according to the type of fabric.

• Empty all pockets and check for loose buttons.

• Close zips and hooks and fasten belts and strings without 

tightening them.

• Wring out garments to remove the maximum amount of 

water possible.

!

 

Do not load the dryer when garments are dripping wet.

Maximum load sizes

Do not overload the drum.

The following values indicate the weight of dry garments:

Natural fibres: maximum 

    

kg

Synthetic fibres: maximum 

     

kg

!

 Do not overload the dryer as this may result is reduced 

drying performance.

Care labels

Always check the care labels, especially when placing 

garments in the tumble dryer for the first time. Below are the 

most commonly used symbols:

 

 

May be tumble dried.

 

 

Do not tumble dry.

 

 

Tumble dry – high heat.

 

 

Tumble dry – low heat.

Drying times

Drying times are approximate and may vary depending on 

the following:

•  Amount of water retained by items after the spin cycle: 

towels and delicate items retain a lot of water.

•  Fabrics: items of the same fabric, but with different texture 

and thickness may have different drying times.

•  Amount of laundry: single items and small loads may take 

longer to dry. 

•  Drying: if items are to be ironed, they can be removed 

from the dryer while still slightly damp. Items that require 

complete drying can be left longer.

•  Heat setting. 
•  Temperature of the room: the lower the temperature of the 

room, the longer it will take for the dryer to dry clothing.

•  Bulk: certain bulky items require special care during the 

drying process. We suggest removing these items and 

replacing them in the dryer once they have been shaken 

out: repeat this procedure several times during the course 

of the drying cycle.

!

 Do not over-dry items.

All fabrics contain natural dampness which helps to keep 

them soft and fluffy.

Laundry

Troubleshooting

 

Possible causes / Solution:

•  The plug is not plugged into the socket, or not making contact.

•  There has been a power failure.

•  The fuse has blown. Try to plug another appliance into the socket.

•  You are using an extension cord? Try to plug the dryer’s power cord directly into the 

socket.

•  The door is not closed securely?

•  The PROGRAMMES knob has not been set properly 

(see Start and Programmes)

.

•  The Start/Pause button has not been pressed 

(see Start and Programmes).

•  

On machines equipped with “Locked” function, check the option is not enabled 

(see 

Programmes and options).

•   You have set a delayed time 

(see Start and Programmes).

•  The filter has not been cleaned 

(see Care and Maintenance)

.

•  The correct programme has not been selected for the type of fabric you are drying 

(see Start and Programmes)

•  The flexible vent tube is obstructed 

(see Installation)

•  The air intake grille is obstructed 

(see Installation)

.

•  The permanent ventilation flap on the storm cover is obstructed 

(see Installation)

.

•  The items were too wet 

(see Laundry).

•  The dryer was overloaded 

(see Laundry)

.

!

   For safety the dryer has a maximum programme time of 5 hours. If an automatic 

programme has not sensed the required final moisture in this time the dryer will 

complete the programme and stop. Check the above points and run the programme 

again, if the results are still damp, contact the Service Centre 

(see Service)

.

•  Try turning the dryer off and remove the plug. Then replace the plug and turn on, if 

a fault is still shown when you turn the dryer back on: note the lights that are on (not 

flashing) and contact the Service Centre 

(see Service)

.

Problem:

The tumble dryer won’t start.

Drying cycle will not begin.

Its taking a long time to dry.

Programme finishes and clothes are 

damper than expected..

The START/PAUSE light flashes 

amber and all Option lights also 

flash to indicate a fault.

One day your dryer seems not to be working. Before you call your Service Centre 

(see Service)

, go through the following 

troubleshooting suggestions: 

Summary of Contents for TVFS 73













Reviews: