Hotpoint TVFG 65 Futura, Instruction Booklet

Page: 9 / 20

9
GB
Start and Programmes
Choosing a programme
1. Plug the dryer into the electrical socket.
2. Sort your laundry according to fabric type ( see
Laundry ).
3. Open the door and make sure the filter is clean
and in place (
see Maintenance ).
4. Load the machine and make sure items are not
in the way of the door seal. Close the door.
5. If none of the lights are on: Press the ON/OFF
button .
6. Choose a programme by checking the Programmes
Guide (
see Programmes ) as well as the indications
for each type of fabric ( see Laundry ).
- Select a programme by rotating the
PROGRAMMES knob.
7. Choose Timed Drying or Dryness Levels option:
- If Timed Dry press and release the Timed
button until the required time is displayed.
or - To change from default dryness setting, press
and release the Sensor Dry button until the
required level is indicated (
see The Display ).
8. Set a delay time and other options if necessary.
9. The START/PAUSE light is flashing green:
- press the START/PAUSE button to begin.
The green light stops flashing.
During the drying programme, you can check on
Bed & Bath
●
This is a programme for cotton towels and sheets.
●
The duration of this programme will depend on the size of the load, the dryness setting selected and the spin
speed used in your washer (
see Laundry ).
●
Loads dried using the Extra Dry setting are usually ready to use, the edges or seams may be slightly damp
especially on large items. If this is the case, try opening them out and running the programme again for a short
period.
Standard Cotton
●
This is a programme for cotton items.
●
The duration of this programme will depend on the size of the load, the dryness setting selected and the spin
speed used in your washer (
see Laundry ).
●
The Standard Cotton programme to EU Regulation 392/2012 is Programme 1 selection with High Heat and
Dryness Level Cupboard Dry
(the standard/default starting configuration). It is the most efficient programme in terms
of energy consumption (to EU.392/2012).
your laundry and take out items that are dry
while others continue drying. When you close
the door again, press the START/PAUSE button in
order to resume drying.
(
When the door is opened the START/PAUSE light
will flash Amber, after the door is closed and the
START/PAUSE button pressed, the START/PAUSE
light will stop flashing and show green.
)
Note: During the Post Care phase this light
flashes Amber.
10. At the end of the drying cycle the display shows
END and either :
- The buzzer will beep 3 times to let you know
that your programme is complete. (
Note : If
the SOUND option was selected the buzzer
beeps 3 times every 30 seconds for 5
minutes).
or - If you have selected the Crease Care option
and you do not take the items out immediately,
the items will tumble occasionally for 10
hours or until you open the door, the buzzer
will then beep 3 times to confirm the
programme is completed.
11. Open the door, take the laundry out, clean the filter
and replace it ( see Maintenance ).
12. Unplug the dryer.
Programme Options available
1
Standard Cotton
4
Synthetics
6
Synthetics Quick Dry
5
Cottons Quick Dry
3
Bed & Bath
ESSENTIAL PROGRAMMES -
Programmes Table
2
Shirts
✗
✗
✗
✓ ✗
✗
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓ ✓
✓
✓
✓
✓
✓
✓
✗
✓
✓ ✓
✓
✗
✓
✓
✓
✓
✓
✓ ✓ ✓
✗
✓
Dryness Levels available
(default highlighted )
Dela
y Timer
*Crease Care or Sound Heat Le
vel
Timed Dr
y
Sensor Dr
y
Damp Dr
y
Ir
on Dr
y
Hang
er Dr
y
Cupboar
d Dr
y
Extra Dr
y
●
An Automatic programme
●
An Automatic programme
* YOU CANNOT SELECT BOTH CREASE CARE AND SOUND OPTIONS
- High
- Medium
- Low
- High
- Medium
- High
- Medium
- Medium
- Low