GB
9
Programme selection knob
Allows for setting the programme: turn until the indicator points towards the desired programme
. The OFF position switches off the
dryer
(see Starting and selecting a programme).
Options buttons
Allow for selecting the options available for the selected programme. The relative indicator lights turn on when the option has been
selected
(see Programmes and options).
START/PAUSE button and indicator light
When the green light flashes slowly, press the button to start the programme. When the cycle is under way, the indicator light remains
on. To put the programme into pause mode, press the button again; the indicator light will turn orange and start flashing again.
To resume the programme from the point it was interrupted, press the button again
(see Start and programme selection).
Indicator lights
“Maintenance” indicator lights
The indicator lights provide important information. They indicate the following:
Before each programme, the indicators light
CLEAN FILTER and
EMPTY WATER signals that it is essential to clean the filter
and the water container must be emptied, before using the tumble dryer
(see Care and maintenance).
If the water container fills during the course of the programme, the LED lights up. The water container must be emptied before pressing
the START/PAUSE button to resume the cycle from the point it was interrupted.
The “Clean condenser unit” indicator light
(CLEAN CONDENSER) signals that it is essential to clean the condenser regularly
(see
Care and maintenance).
“Drying phases” indicator lights
The
DRYING
indicator light signals that the drying phase is running.
The
COOL TUMBLE
indicator light signals that the cooling phase is running.
The
END
indicator light signals that
the programme has ended.
“Delay timer” indicator light
If the ”Delay timer” option has been activated
(
see “Programmes and options”
), after the programme has started, the indicator light
corresponding to the chosen delay time will start flashing:
As time passes, the remaining delay will be displayed and the corresponding indicator light will flash:
Once the set delay time ends, the flashing LED will turn off and the set programme will start.