7
EN
MAINTENANCE AND
CLEANING
Download the Use and Care Guide from
docs.hotpoint.eu
for
more information
Do not use steam cleaners.
Use protective gloves during all operations.
Carry out the required operations with the oven
cold.
Disconnect the oven from the power supply.
Do not use wire wool, abrasive scourers or
abrasive/corrosive cleaning agents, as these could
damage the surfaces of the appliance.
EXTERIOR SURFACES
. Clean surfaces with a damp microfibre cloth. If they
are very dirty, add a few drops of pH-neutral detergent.
Finish off with a dry cloth.
. Do not use corrosive or abrasive detergents. If any of
these products inadvertently comes into contact with
the surfaces of the appliance, clean immediately with a
damp microfibre cloth.
INTERIOR SURFACES
. This oven is equipped with special catalytic panels
that facilitate cleaning of the cooking compartment
thanks to their special self-cleaning coating, which is
highly porous and able to absorb grease and grime.
After every use, leave the oven to cool and then clean
it, preferably while it is still warm, to remove any
deposits or stains caused by food residues. To dry any
condensation that has formed as a result of cooking
foods with a high water content, leave the oven to cool
completely and then wipe it with a cloth or sponge.
. Clean the glass in the door with a suitable liquid
detergent.
. The door can be easily removed and refitted to
facilitate cleaning of the glass
WWW
.
• The top heating element of the grill can be lowered to
clean the upper pane of the oven: Extract the heating
element from its seating, then lower it. To return the
heating element to its position, lift it up, pull it slightly
towards you and make sure that the tab support is in its
proper seating.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
REMOVING AND REFITTING THE DOOR
1.
To remove the door, open it fully and lower the
catches until they are in the unlock position.
2.
Close the door as much as you can.
Take a firm hold of the door with both hands – do not
hold it by the handle.
Simply remove the door by continuing to close it
while pulling it upwards (a) at the same time until it is
released from its seating (b).
~60°
a
b
~15°
Put the door to one side, resting it on a soft surface.
3.
To refit the door, move it towards the oven, aligning
the hooks of the hinges with their seating and securing
the upper part onto its seating.
4.
Lower the door and then open it fully. Lower the
catches into their original position: Make sure that you
lower them down completely.
5.
Try closing the door and check to make sure that it
lines up with the control panel. If it does not, repeat the
steps above.
CLICK&CLEAN - CLEANING THE GLASS
1.
After removing the door and resting it on a
soft surface with the handle facing downwards,
simultaneously press the two retaining clips and
remove the upper edge of the door by pulling it
towards you.
2.
Lift and firmly hold the inner glass with both hands,
remove it and place it on a soft surface before cleaning
it.
3.
To correctly reposition the inner door glass, ensure
that the letter "R" is visible on the left corner.
First insert the long side of the glass indicated by “R”
into the support seats, then lower it into position.
4.
Refit the upper edge: a click will indicate correct
positioning. Make sure the seal is secure before refitting
the door.
WWW
