EN
2
Installation
!
Read these instructions carefully before using your
microwave oven, and keep it carefully.
If you follow the instructions, your oven will provide you
with many years of good service.
!
SAVE THESE INSTRUCTIONS CAREFULLY
PRECAUTIONS TO AVOID POSSIBLE EXPOSURE
TO EXCESSIVE MICROWAVE ENERGY.
a) Do not attempt to operate this oven with the door
open since this can result in harmful exposure to
microwave energy. It is important not to break or
tamper with the safety interlocks.
b) Do not place any object between the oven front
face and the door or allow soil or cleaner residue to
accumulate on sealing surfaces.
c) WARNING: If the door or door seals are damaged, the
oven must not be operated until it has been repaired
by a competent person.
ADDENDUM
If the apparatus is not maintained in a good state of
cleanliness, its surface could be degraded and affect the
lifespan of the apparatus and lead to a dangerous situation.
Installation and Connection
1. This appliance is only intended for domestic use.
2. This oven is intended for built-in use only.It is not
intended for counter-top use or for use inside a
cupboard.
3. Please observe the special installation instructions.
4. The appliance can be installed in a 60cm wide
wallmounted cupboard(at lease 55cm deep and
85cm off the floor).
5. The appliance is fitted with a plug and must only be
connected to a properly installed earthed socket.
6. The mains voltage must correspond to the voltage
specified on the rating plate.
7. The socket must be installed and connecting cable
must only be replaced by a qualified electrician.If the
plug is no longer to accessible following installation,an
all-pole disconnecting device must be present on the
installation side with a contact gap of at lease 3mm.
8. Adapters,multi-way strips and extension leads must
not be used. Overloading can result in a risk of fire.
The accessible surface may be hot
during operation.
Please Read the Manual Carefully Before
Installation
Please note
Electrical connection
The oven is fitted with a plug and must only be
connected to a properly installed earthed socket. The
socket must only be installed and the connecting cable
must only be replaced by a qualified electrician, and in
accordance with the appropriate regulations.
If the plug is no longer accessible following installation,
an all-pole isolating switch must be present on the
installation side with a contact gap of at least 3 mm.
The fitted cabinet must not have a back wall behind the
appliance.
Minimum installation height: 85 cm.
Do not cover ventilation slots and suction holes.
Note:
Do not trap or bend the power cable.
A. Built-in furniture
380+2
