GB
15
Changing a water
filter cartridge
1. Locate the water
filter cartridge cap
below the freezer
compartment door.
Rotate the cap
counterclockwise to a
vertical position and pull
the cap and filter cartridge out through the base grille.
Note:
Since there is water in the cartridge, some
spilling may occur.
2. Remove the
cartridge cap by sliding
it off the end of the old
cartridge. DO NOT
DISCARD THE CAP.
3. Take the new
cartridge out of its
packaging and remove
the protective cover
from the o-rings.
4. Slide the cartridge
cap onto the new
cartridge as shown.
5. With cartridge cap in
the vertical position,
push the new filter
cartridge into the base
grille until it stops.
Rotate the cartridge cap
clockwise to a horizontal
position.
6. RUN WATER THROUGH THE DISPENSER UNTIL
THE WATER RUNS CLEAR (about 9-14 litres or 6-7
minutes). This will clean the system and clear air from
the lines.
Note:
as air is cleared from the system, water may
spurt out of the dispenser.
Ordering replacement filters
To order more water filter cartridges, please contact
your after-sales service.
imp. HOTPOINT sidebyside 26-03-2007 10:39 Pagina 15
