hotpoint.
co.uk
9
8
en
en
improper grounding installation
can result in electrical shock.
This appliance must be earthed.
in the event of an electrical
short circuit, this reduces the
risk of electrical shock. This
appliance is supplied with a
moulded three pin mains plug
for your safety and convenience.
The plug must be plugged
into an outlet that is properly
installed and earthed. consult
a qualified electrician or service
technician if the instructions are
not completely understood or to
ensure the appliance has been
properly earthed. If required, use
a 3-wire extension cord, only.
If an extension cord is used:
1) The marked electrical
rating of the cord should be at
least
as great as the
electrical rating of
the
appliance.
2) The cord should never drape
over the counter-top or
tabletop where it can be pulled
on by children or tripped over
unintentionally.
INSTALLATION
1.Select a level surface that
provides enough open space for
the intake and/or outlet opening
vents.
(1) The minimum installation
height should be not less than
80cm.
(2) The rear surface of the
appliance shall be placed
against a wall. Leave a minimum
clearance of 30cm above the
oven; a minimum clearance of
20cm is required between the
oven and any adjacent walls.
(3) Do not remove legs from
the bottom of the oven.
(4) Blocking the intake and/or
outlet openings can damage
the oven.
(5) Place the oven as far
away from radios and Tv as
possible. operation of microwave
oven may cause interference to
your radio or Tv reception.
2. Plug your oven into a standard
household outlet. Be sure the
voltage and the frequency is
the same as the voltage and the
frequency on the rating label.
Do not install oven over any
cooktop/hob or other heat-
producing appliance. if installed in
proximity of or over sources of
heat, the oven could be damaged
and the warranty would be void.
Do not remove the light brown
mica cover that is attached to
the oven cavity to protect the
magnetron.
OPERATION INSTRUCTIONS
This microwave oven uses modern electronic
controls to adjust cooking parameters and meet
your cooking needs.
CLOCk SETTING
When the microwave oven is Powered ON, the
oven will display “0:00”. The buzzer will ring once.
1) Press “
” once, until “00:00” displays;
2) Turn the
kNOb
to adjust the hour figures, the
input time should be within 0--23.
3) Press “
”, the minute figures will flash.
4) Turn the
kNOb
to adjust the minute figures,
the input time should be within 0--59.
5) Press “
” to finish clock setting. “:” will flash.
Note:
During clock setting, the oven will
automatically go back to the previous
status after 1 minute of inactivity.
TImER
(1) Press “
” twice, until the LED will display
00:00.
(2) Turn the
kNOb
and enter time on the timer.
(The maximum cooking time is 95 minutes).
(3) Press “
START/+30SEC.
“ to confirm setting.
(4) When the time ends, the buzzer rings 5 times.
if the clock has been set (24-hour system), the
LeD will display the current time.
Note:
while the timer is in operation, no
other program can be set.
mICROwAVE COOkING
1) Press the “
” key once, and “P100” display.
2) Press “
” repeatedly or turn the
kNOb
to
select the microwave power; “P100”, “P80”,
“P50”, “P30”, “P10” will display in order.
3) Press “
START/+30SEC.
“ to confirm.
4) Turn the
kNOb
to adjust the cooking time.
(Time setting should be 0:05- 95:00.)
5) Press “
START/+30SEC.
” to start cooking.
The accessible
surface may be
hot during operation.
TURNTAbLE INSTALLATION
Hub (underside)
Glass turntable
Turntable spindle
Turntable ring support
a. Never place the glass tray
upside down. The glass tray
should never be restricted.
b. Both glass tray and turntable
ring support must always be
used during cooking.
c. Food and food containers must
always be placed on the glass
tray for cooking.
d. if glass tray or turntable ring
support cracks or breaks, please
contact your nearest authorized
service centre.
COUNTERTOP INSTALLATION
remove all packaging
material and accessories.
inspect the oven for damages
such as dents or broken door. Do
not install if oven is damaged.
Cabinet
:
Remove
any
protective film from the
microwave oven surface.
