10
GB
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
1. Open the oven door fully (see diagram).
2. Use a screwdriver to lift up and turn the small levers
F
located on the two
hinges (see diagram).
F
3. Grip the door on the two outer sides and
close it approximately half way. Pull the
door towards you, lifting it out of its slot (see
diagram). To replace the door, reverse this
sequence.
Inspecting the seals
Check the door seals around the oven regularly. If the seals are damaged,
please contact your nearest Service Centre (see Assistance). We recommend
that the oven is not used until the seals have been replaced.
Replacing the light bulb
To replace the oven light bulb:
1. Remove the glass cover of the
lamp-holder.
2. Remove the light bulb and replace
it with a similar one: halogen lamp
voltage 230 V, wattage 25 W, cap G 9.
3. Replace the glass cover (see
diagram).
!
Do not touch the light bulb directly with your hands.
!
Do not use the oven lamp as/for ambient lighting.
Automatic cleaning with the FAst CLEAN function
With the FAST CLEAN mode, the internal temperature of the oven reaches
500°C. The pyrolytic cycle is activated, burning away food and grime residues.
Dirt is literally incinerated.
Keep children away from the appliance during the automatic cleaning cycle
as surfaces may become very hot. Particles may ignite inside the oven due
to the combustion process. There is no cause for concern: this process is
both normal and hazard-free.
Before initiating the FAST CLEAN mode:
• clean the oven door;
• remove large or coarse food residues from the inside of the oven using a
damp sponge. Do not use detergents;
• remove all accessories and the sliding rack kit (where present);
• Do not place tea towels or pot holders over the oven handle.
• Turn the SELECTOR knob to the “0” position.
!
If the oven is too hot, the pyrolytic cycle may not start. Wait for the oven
to cool down.
!
The programme may only be started once the oven door has been closed.
Glass cover
Lamp
Lamp
Holder
compartment
To activate the FAST CLEAN cycle press and hold the
button for
approximately 4 seconds. The TIMER KNOB may be used to select the
desired cleaning level; there are three default time settings which cannot
be modified.
1. Economy (ECO): turn the knob towards “ ”. Duration 1 hour.
2. Normal (NOR): initial level. Duration 1 hour and 30 minutes.
3. Intensive (INT): turn the knob towards “ ”. Duration 2 hours.
4. Press the
button to confirm.
An end time for the FAST CLEAN cycle (as for a normal cooking cycle)
may be programmed (see Programming the automatic cleaning end time).
safety devices
• the
icon on the display, when lit, indicates that the oven door was
automatically locked as soon as the temperature reached a high value.
• the
icon indicates that the cleaning cycle may be cancelled at
any time by pressing the
button.
• if a malfunction occurs, the heating elements will be switched off.
• once the oven door has been locked, you cannot change the duration and
cycle end time settings.
programming the automatic cleaning end time
1. Press the
button until the
icon and the two digits on the
DISPLAY begin to flash.
2. Turn the TIMER KNOB towards “ ” and “
” to adjust the hour value.
3. Press the
button again until the other two digits on the DISPLAY
begin to flash.
4. Turn the TIMER KNOB towards “ ” and “
” to adjust the minute value.
5. Press the
button again to confirm.
6. When the set time has elapsed, the text END appears on the display
and a buzzer sounds.
• For example: it is 9:00 a.m. and the Economy (ECO) FAST CLEAN level
has been selected, with the default duration of 1 hour. 12:30 is scheduled
as the end time. The programme will start automatically at 11:30 a.m.
Programming has been set when the
and
buttons are
illuminated. The display shows the FAST CLEAN end time and duration
alternately.
Once the automatic cleaning cycle is over
You will have to wait until the temperature inside the oven has cooled down
sufficiently before you can open the oven door. You will notice some white
dust deposits on the bottom and the sides of your oven; remove these
deposits with a damp sponge once the oven has cooled down completely.
Alternatively, you can make use of the already heated oven, in which case
it is not necessary to remove the deposits, they are completely harmless
and will not affect your food in any way.
