GB
13
Troubleshooting
Malfunctions:
The display is completely switched off.
The motor does not start.
The display is on but it is dim.
The alarm sounds, a message
appears on the display, the ALARM
LED lights up and the refrigerator
light flashes.
The alarm sounds, the ALARM LED
lights up and a message appears on
the display.
The alarm sounds, the ALARM LED
flashes and a message appears on
the display.
The refrigerator and the freezer do not
cool well.
The food inside the refrigerator is
beginning to freeze.
The motor runs continuously.
The Aircooler fan does not rotate
The appliance makes a lot of noise.
Early ending of functions
A message appears on the display
(e.g. F01)
Possible causes / Solutions:
• The plug has not been inserted into the electrical socket, or not far enough
to make contact, or there is no power in the house.
• The appliance comes with a motor protection control (
see Start-up and use).
• Pull out and reverse the plug before putting it back in the socket.
• The refrigerator door has been open for more than two minutes.
The buzzer stops when the door is closed or when the RESET ALARM
button is pressed.
• The temperature inside the freezer is too high.
The freezer will maintain a temperature of around 0°C so that the food will
not refreeze, allowing you to eat it within 24 hours or to refreeze it after it
has been cooked.
To switch off the buzzer, press the RESET ALARM button. Press again to
delete the message on the display, switch off the ALARM LED and restore
normal operation.
• The temperature of the freezer is dangerously high: the food inside must not
be eaten. The freezer will maintain a temperature of approximately 0°C.
To switch off the buzzer, press the RESET ALARM button. Press again to
delete the message on the display, switch off the ALARM LED and restore
normal operation.
• The doors do not close properly or the seals are damaged.
• The doors are opened too frequently.
• The temperature that has been set is too high (
see Start-up and use).
• The refrigerator or the freezer have been over-filled.
• The temperature that has been set is too low (
see Start-up and use).
• The SUPER FREEZE button has been pressed (rapid freezing): the yellow
SUPER FREEZE light is on or flashing (
see Description).
• The door is not closed properly or is continuously opened.
• The outside ambient temperature is very high.
• The thickness of the frost exceeds 2-3 mm (
see Maintenance).
• The refrigerator door is open.
• The Aircooler system is only activated automatically when it becomes
necessary to restore perfect operational conditions inside the refrigerator
compartment.
• The appliance has not been installed on a level surface (
see Installation).
• The appliance has been installed between cabinets that vibrate and make
noise.
• The internal refrigerant makes a slight noise even when the compressor is
off. This is not a defect, it is normal.
• Electrical disturbance on the network or brief interruptions of the power supply
• The water discharge hole is blocked (
see Maintenance).
Summary of Contents for HME400N
Page 14: ...14 GB Notes...
