7
•
regulate the screw positioned outside the thermostat pin until the flame is small but steady.
N.B.:
in the case of liquid gas, the regulation screw must be screwed in to the bottom.
•
check that the burner does not turn off
when you turn the knob from Max
to Min
and and when you open
and close the oven door quickly.
Adapting the gas grill to different types of gas
Replacing the nozzle of the grill burner:
•
Loosen the screws along the perimeter to remove the rear protection (see diagram)
•
remove screw “
V
” and then the grill burner;
V
•
Unscrew the grill burner nozzle using the socket spanner for the nozzles, or a 7 mm socket spanner, and
replace it with a nozzle suited to the new type of gas (see Table 1).
Take particular care handling the spark plug wires and the thermocouple pipes.
•
Replace all the parts, following the steps described above in the reverse order.
N.B.: No adjustment is needed for minimum setting.
Important
On completion of the operation, replace the old rating sticker with one indicating the new type of gas used.
This sticker is available from our Service Centres.
Note
Should the pressure of the gas used be different (or vary) from the recommended pressure, it is necessary to
fit a suitable pressure regulator onto the inlet pipe in compliance with current National Regulations relative to
“regulators for channelled gas”.
