or
DISPLAY
WHAT IT MEANS
WHAT TO DO
This can be caused by either of
/
--
these reasons:
Not enough water is entering the
Unlatch the door. If there is no water in the bottom of the
dishwasher.
dishwasher, check the water supply to the dishwasher.
●
Is the dishwasher water supply turned on?
(Valve usually located under the sink.)
Is the household water supply turned on?
●
If you use well or cistern water, is the supply adequate?
If the water
is adequate, try the cycle again. If
repeats, call for service.
The drain pump could be
Unlatch the door. If there is standing water in the bottom of
temporarily blocked (usually
the dishwasher,
the door. Touch
then
caused by food particles such
immediately touch “CLEAR/RESET” to start the pump.
as cereal).
If
continues to appear, you may need to do this several
times to breakup the blockage.
--
/
The temperature sensor in the
The temperature sensor needs to be replaced. Call for
dishwasher is not functioning
service.
properly. Dishwasher may
continue to be used, but it will
You may continue to use your dishwasher. For best results,
not heat water automatically.
adjust your household water heater thermostat to
Before you call for service
. Try the cycle again to see if the
Code reappears. The dishwasher
may correct itself.
. Electronic controls can be
affected by outside interference.
●
Sometimes shutting off the power
to the dishwasher (at the fuse or
circuit breaker) will correct the
problem.
●
Restore power after about
seconds and try the cycle again.
. Check the chart above for things
you can do to correct the problem.
9
