GB
7
*
Varies by number and/or position, available only on certain
Start-up and use
Starting the appliance
! Before starting the appliance, follow the installation instructions
(see Installation).
! Before connecting the appliance, clean the compartments and
accessories well with lukewarm water and bicarbonate.
! The appliance comes with a motor protection control system which makes
the compressor start approximately 8 minutes after being switched on.
The compressor also starts each time the power supply is cut off whether
voluntarily or involuntarily (blackout).
1. Set the FREEZER OPERATION knob on
.
2. Insert the plug into the socket and ensure that the green POWER indicator
light illuminates.
3. Turn the REFRIGERATOR OPERATION knob to an average value. After
a few hours you will be able to put food in the refrigerator.
4. Turn the FREEZER OPERATION knob to an average value and press the
SUPER FREEZE button (rapid freezing): the SUPER FREEZE indicator
light will illuminate. Once the refrigerator has reached the optimal
temperature, the indicator light goes out and you can begin food storage.
Chiller system
No Frost
The No Frost system circulates cold air continuously to collect humidity
and prevent ice and frost formation. The system maintains an optimal
humidity level in the compartment, preserving the original quality of the food,
preventing the food from sticking together and making defrosting a thing
of the past. Do not block the aeration cells by placing food or containers
in direct contact with the refrigerating back panel. Close bottles and wrap
food tightly.
Using the refrigerator to its full potential
• Place only cold or lukewarm foods in the compartment, never hot foods
(see Precautions and tips).
• Remember that cooked foods do not last longer than raw foods.
• Do not store liquids in open containers: they will increase the level of
humidity in the refrigerator and cause condensation to form.
SHELVES:
with or without grill.
Due to the special guides the shelves are removable and the height is
adjustable (see diagram), allowing easy storage of large containers and
food. Height can be adjusted without complete removal of the shelf.
TEMPERATURE
Indicator light
*
: to identify the coldest area in the
refrigerator.
1. Check that OK appears clearly on the indicator light (see
diagram).
2. If the word “OK” does not appear it means that the temperature
is too high: adjust the REFRIGERATOR OPERATION knob to a
higher position (colder) and wait approximately 10 hours until
the temperature has been stabilised.
3. Check the indicator light again: if necessary, readjust it following
the initial process. If large quantities of food have been added
or if the refrigerator door has been opened frequently, it is
normal for the indicator not to show OK. Wait at least 10 hours
before adjusting the REFRIGERATOR OPERATION knob to a
higher setting.
Active Oxygen
This device releases ozone molecules inside the refrigerator; ozone
is a natural substance which combats bacteria and microorganisms,
reducing their proliferation while limiting unpleasant odours.
Automatically defines the amount of ozone required for prolonging
the freshness of foodstuffs, eliminating odours and preventing
bacteria build-up.
There may be a slight distinctive odour inside the refrigerator. The
very same smell can sometimes be detected during a storm, due to
the ozone produced as the charge in the lightning bolts is released;
this is completely normal. The amount produced by the device is
very small and abates quickly as the antibacterial action takes place.
Device is activated pressing the dedicated key on the dashboard.
With the Active Oxigen switched on, the device will operate a repeted
cycle until the key is pressed again. There will be an Ozone emission
noticed by the switching on of the green led located on the Active
Oxigen device located in the fridge compartment and a stand-by
cicle (without zone emission) noticed by blue light.
Summary of Contents for FFFL1810GO3UK
Page 11: ...11 ...
