GB
13
Extra Drying
Option
To improve the dryness level of the crockery, press
the EXTRA DRYING button and the symbol/indicator
light will light up. If it is pressed again, the option will be
deselected.
A higher temperature during the final rinsing and a longer
drying phase improve the dryness level.
The EXTRA DRYING option increases the duration of the
wash cycle.
Delayed Start option
It is possible to delay the start time of the cycle by
1
to
24
hours:
1. Select the desired wash cycle and any other options
required, press the DELAYED START button. The relevant
symbol starts flashing. Use the b and - to select when
the wash cycle will start (h01, h02 etc.)
2. Confirm with the START/PAUSE button. The symbol stops
flashing and the countdown begins.
3. Once this time has elapsed, the DELAYED START symbol
switches off and the wash cycle begins.
To deselect the DELAYED START option, press the DELAYED
START button until the text
OFF
appears.
The Delayed Start function cannot be set once a wash
cycle has been started.
Wash options
The OPTIONS may only be set, changed or reset after the
wash cycle has been selected and before the Start/Pause
button has been pressed.
Only the options which are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected wash cycle
(see Table of wash cycles)
, the
corresponding symbol/indicator light flashes rapidly 3 times.
If an option is selected which is not compatible with another
(previously selected) option, it will flash 3 times and switch
off, while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press
the corresponding button again.
Multi-functional Tablets Option
(Tabs)
This option optimises washing and drying results.
When using multi-functional tablets, press the MULTI-
FUNCTIONAL TABLETS button; the corresponding symbol/
indicator light will light up. If the button is pressed again, the
option will be deselected.
The “Multi-functional tablets” option results in a longer
wash cycle.
Special wash cycles
and Options
Notes:
Optimum performance levels when using the “Fast wash” and
“Express 30’” cycles can be achieved by respecting the specified
number of place settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories:
for information on comparative EN
testing conditions, please send an email to the following address:
[email protected]
Short Time Option
This option can be used to reduce the duration of
the main wash cycles while, maintaining the same washing
and drying performance levels. After selecting the wash cy-
cle, press the SHORT TIME button; the illumination of the
corresponding symbol/indicator light indicates its selection.
Press it again to deselect it.
Zone Wash Option
This option makes it possible to carry out the wash
cycle in the selected rack only. Select the wash cycle
and then press the ZONE WASH button: the selected rack
lights up and the wash cycle starts in the selected rack only.
Press the button again to deselect the option.
The option is available with the following wash cycles:
Intensive
and
Normal
.
Select the option and the
Intensive
cycle to start the
ULTRAINTENSIVE ZONE washing. This wash cycle is ideal
for very soiled mixed loads, e.g. pans and saucepans, dishes
with heavy encrustation or difficult-to-clean crockery (grater,
vegetable mill, dirty cutlery). The spraying pressure is stronger
and the washing temperature higher, thus ensuring optimum
handling of stubborn stains.
Select the option and the
Normal
cycle to start the SAVING
ZONE washing. This function makes it possible to reduce
energy consumption. Cycle duration might change
Remember to load the crockery in the selected rack only.
*
Only available in selected models.
