7
When Your Refrigerator Is First Plugged In
How the Monitor and Diagnostic System Works
All panel lights come on for five seconds,
a beep sounds, and lights go off except
as follows:
■
PF
flashes in the display. Touch
SYSTEM CHECK-RESET
to erase it.
■
NORMAL
glows.
■
WARM TEMP
glows until the refrigerator
cools down. It goes off when proper
food-keeping temperature is reached.
■
Door alarm beeper is activated and
DOOR ALARM
glows.
■
CRUSHED ICE
glows.
■
DOOR OPEN
flashes if either door is
open, goes out when doors are shut.
■
Night light in ice and water dispenser
is off.
How to Set the Door Alarm
To set the alarm press
DOOR ALARM
until it glows.
The control beeps if either door is
open for more than 30 seconds.
The light goes out and the beeping
stops when you close the door.
DOOR ALARM
ON/OFF
Why the WARM TEMP Light Glows
At first, it’s probably because your newly-
installed refrigerator hasn’t completely
cooled down yet. Wait a few hours for it
to cool, and then the light will go out.
From then on,
WARM TEMP
will glow
whenever temperatures inside get too
high for proper food storage. If this
happens, open the doors only when
absolutely necessary, and close them
as quickly as possible.
As soon as inside temperatures return to
normal, the light goes out.
If
WARM TEMP
reappears and stays on
for longer than 4 hours, call for service.
WARM
TEMP
The diagnostic code flashes and the
control beeps when something starts to
go wrong.
If more than one coded function requires
attention at the same time, the one with
the highest priority will be displayed first.
Pressing
SYSTEM CHECK-RESET
will erase
two codes immediately—
PF
and
CI.
The
dE
and
FF
codes can only be erased by
pressing
SYSTEM CHECK-RESET
after the
condition that caused the code to flash
has been corrected.
SYSTEM CHECK-RESET
will also evaluate
all other coded functions. If
NORMAL
is
lit during the displaying of a code, that
function is operating properly.
SYSTEM
CHECK
RESET
