GB
14
Troubleshooting
Possible causes / Solutions:
The plug has not been inserted into the electrical socket, or it has not
been inserted far enough to make contact.
There is no power in the house.
The porthole door has not been shut properly.
The START/PAUSE button has not been pressed.
The water tap has not been turned on.
The water inlet hose is not connected to the tap.
The hose is kinked.
The water tap has not been turned on.
There is no water in the house.
The water pressure is insufficient.
The START/PAUSE button has not been pressed.
The end of the outlet hose has not been fitted at a height between 65
and 100 cm from the floor (
see Installation).
The free end of the hose is underwater (
see Installation).
If If the dwelling is on one of the upper floors of a building, there may
be problems relating to water drainage, causing the washer-dryer to
load and drain water continuously. Special anti-draining valves are
available in shops and help to avoid this inconvenience.
The water drainage systemis not fitted with a breather pipe.
The programme does not include a draining phase: some programmes
require manual draining (
see Programmes and options).
The Easy Iron option is enabled: to complete the programme, press
the START/PAUSE button
(see Programmes and options).
The outlet hose is bent (
see Installation).
The drainage duct is clogged.
The drum was not unlocked properly when the appliance was installed
(see Installation).
The washer-dryer is not level (
see Installation).
The washer-dryer is trapped between cabinets and a wall
(see Installation).
The load is not balanced properly (
see Description of the machine).
The water inlet hose is not screwed on to the tap correctly (
see Installation).
The detergent dispenser drawer is blocked (for instructions on how to
clean it,
see Care and maintenance).
The outlet hose has not been secured properly (
see Installation).
Switch off the machine and unplug the appliance; wait for
approximately 1 minute then switch it on again.
If the problem persists, contact Assistance.
The detergent is not designed for machine washing (the packaging should state that
the product is for washing by machine, for washing by hand or machine or similar).
Too much detergent was used.
Follow the manual unlocking procedure
(see Precautions and tips).
The appliance is not plugged into the socket, or not enough to make contact.
There has been a power failure.
The appliance door is not shut properly.
A delayed start has been set.
The DRYING cycle is on the
OFF
setting.
From time to time your machine may not operate as it should. Before calling for Assistance (
see Assistance)
,
make sure that the problem cannot be resolved easily using the following list.
Malfunction:
The washer-dryer
will not switch on.
The wash cycle
does not begin.
The washer-dryer fails to fill
with water.
The machine continuously fills
and drains water.
The washer-dryer does not
drain or spin.
The washer-dryer vibrates
too much during the spin cycle.
The washer-dryer leaks.
The icons corresponding to
the Phase in progress flash
rapidly at the same time as
the ON/OFF indicator light.
There is too much foam.
The washer-dryer door remains locked.
The washer-dryer does not dry.
