Hotpoint Aqualtis AQ114F 49D Instructions For Installation And Use Manual Download Page 9

EN

9

TEMPERATURE  

button

WASH CYCLE 

SELECTOR

 

knob

OPTION 

buttons 

with indicator lights

LOCK

 

indicator light

START/ 
PAUSE

 

button with  
indicator light

WASH 

CYCLE 
PHASE

 

icons

 

SPIN

 

button

CHILD LOCK 

button 

with indicator light

Button with

 

ON/OFF 

indicator light

ECO  

indicator light

OPTION 

buttons 

with indicator lights

Control panel

Button with 

 

ON/OFF

 indicator light: press this briefly 

to switch the machine on or off. The green indicator light 
indicates that the machine is switched on. To switch off the 
washing machine during the wash cycle, press and hold 
the button for approximately 3 seconds; if the button is 
pressed briefly or accidentally the machine will not switch 
off. If the machine is switched off during a wash cycle, this 
wash cycle will be cancelled.

WASH CYCLE SELECTOR

 

knob: may be turned in 

either direction. To select the most suitable wash cycle, 
please refer to the 

“Table of wash cycles”.

The knob will not move during the wash cycle.

TEMPERATURE

 

 button: press to modify or exclude 

the temperature setting; the value selected will appear on 
the display above 

(see “Running a wash cycle”).

SPIN CYCLE

 

 button: press to modify or exclude the 

spin cycle; the value selected will appear on the display 
above 

(see “Running a wash cycle”).

DELAY TIMER

   button: press to set a DELAY TIMER 

for the selected wash cycle; the set delay time will appear 
on the display above 

(see “Running a wash cycle”).

OPTION

 buttons with indicator lights: press to select the 

available options. The indicator light corresponding to the 
selected option will remain lit 

(see “Running a wash cycle”).

WASH CYCLE PHASE

 icons: these illuminate to indicate the 

progress of the wash cycle (Wash 

 – Rinse 

 – Spin 

 – 

Drain

 

). The text 

 lights up when the cycle is complete.

START/PAUSE 

button with indicator light: when the green 

indicator light flashes slowly, press the button to start a 
wash cycle. Once the cycle has begun the indicator light 
will remain lit in a fixed manner. To pause the wash cycle, 
press the button again; the indicator light will flash in an 
orange colour. If the “LOCK”   indicator light is switched 
off, the door may be opened. To start the wash cycle from 
the point at which it was interrupted, press the button 
again.

LOCK

 

 indicator light: indicates that the porthole door 

is locked. To open the door, pause the wash cycle (see 

Running a wash cycle

”).

CHILD LOCK

 

 button with indicator light: to activate 

or deactivate the CHILD LOCK, press and hold the button 
for approximately 2 seconds. when the indicator light is 
illuminated, the control panel is locked (apart from the 
ON/OFF button). This means it is possible to prevent wash 
cycles from being modified accidentally, especially where 
there are children in the home.

ECO

 indicator light: the 

 icon lights up when, after 

altering the washing parameters, an energy saving of 
at least 10% is made. Furthermore, before the machine 
enters “Standby” mode, the icon will light up for a few 
seconds; when the machine is switched off the estimated 
energy saving will be around the 80% mark.

DELAY TIMER

 

button

DISPLAY

Summary of Contents for Aqualtis AQ114F 49D

















Reviews: