Smart Wifi Multi Stage Thermostat
Reference No.:
HTW-81-FN7WF Series
6/7
2.
After completed the time setting, Press
to switch to the temperature setting, setting temperature flash and press
or
to modify the setting temperature.
3.
After finished the above steps, press
to switch to 2
nd
period of Monday and repeat item 1 and 2 steps, then complete 4
periods of Monday setting. Press
to save and enter schedule setting for the following day.
The below table is the time parameter setting in different modes:
(Factory Default)
Periods
Time
Parameters
Fan
Heating
Cooling/ Auto
1
06
：
00
21.0
℃
25.5
℃
Fan on
2
08
：
00
16.5
℃
29.5
℃
Fan on
3
18
：
00
21.0
℃
25.5
℃
Fan on
4
22
：
00
16.5
℃
28.0
℃
Fan on
（
Notes:Cooling and Auto mode use the same setting schedule.
）
Hold
This mode comes after “
Schedule
” by pressing
F
. In this mode, device will keep a constant temperature until next change.
“Hold”
& “
” display and temperature value flashing. Press
or
can change the value, and press
F
to save
the setting;
Press
can set system state;
Press
can set fan mode.
Hold Until (Holiday)
This mode comes after “
Hold
”by pressing
F
again. In this mode, device will follow the setting temperature and lasting days when
users are out for a holiday. And then back to follow
Schedules
after the holiday.
“Hold Until”
& “
” display and temperature value flashing. Press
or
can change the value, and press
F
to
save the setting. Then days value flashing, users can choose from 1-180 days by pressing
or
;
Press
can set system state;
Press
can set fan mode.
Override temperature setting
During any Schedule period, press
or
can enter an interface for temperature setting. Press
or
to change
setting temperature, and press
F
to save the change. The changed setting only valid in the current Schedule period, device will
follow the original schedule in next period.
Filter cleaning reminder
“
” will flash on the screen to remind users of cleaning furnace filter, and 90 calendar days are the default timing. In
Schedule
mode, to press
for 3 sec, “
” will disappear from screen.
Sensor error
If “
FF
” flashes at temperature display area, it means the temp. sensor is out of work(short-circuit or broken-circuit), all the
outputs will be forced close, and only back to normal work until the sensor circuit is normal again.
Reset to factory default value
Press
&
for 3 sec.
