Wireless Thermostat(Transmitter)
Reference No.:HTW-31-KT13T Series
Temp. Calibration
Code Pairing & Code Unlink(If With)
-
Press and hold the
SET
button for around 3 seconds. The minutes display (top left in
the display) flashes.
-
Change this value using the
+
and
–
buttons.
-
Press the
SET
button . The hour display (top left in the display) flashes.
-
Change this value using the
+
and
–
buttons.
-
Press the
SET
button. The day display (top left in the display) will flash as a number.
-
Change this value using the
+
and
–
buttons.
Use 1 for Monday, 2 for Tuesday, 3 for
Wednesday, 4 for Thursday, 5 for Friday, 6 for Saturday and 7 for Sunday.
Turn thermostat off, long press SET button to enter Sensor calibration. Range: -8°C~+8°C
a) At control centre(HTW-31-X8 ), press KEY button(K1-K8), indicator flashing
b) On thermostat, turn off thermostat, hold “SET” button for 3 seconds, it will show the code on
dispaly, then press “SET” button again,, until the indicator on control centre(LED1-LED8) stop
flashing, code pairing finish.
c) You can check if thermostat and HTW-31-X8 work fine by setting the temp higher than room
temp, then system should start heating, when heating, the LED on HTW-31-X8 will on, that
means the corresponding actuator is working now. ID Pair success.
d) If you want unlink the thermostat and HTW-31-X8 channel, you can power off HTW-31-X8, then
power on the HTW-31-X8 and long press the channel KEY button within 1 minutes, when you
see that Channel on and off, the unlink success.
Clock Adjustment
