There are two selections available for
chain B only
:
•
None: no input, then chain B will turn gray to indicate chain B not working:
•
Chain
A
: Receives outputs from chain A, in this case, the chain A and B connects in series (see
Effects Chain Types
section
INPUT CH
lets you select the signal input channel:
•
L/R: For FX loop return jack, the left channel is connected to tip conductor and the right channel is connected to ring:
For USB outputs, even number stands for left channel (3, 5, 7) and odd number stands for right channel (4, 6, 8)
•
Sum: Sums input signal to mono
•
Stereo: Receives L/R stereo inputs
LEVEL
lets you adjust input level from Mute~-60dB~+20dB. Default is set to 0dB (unity gain).
Output Node Setup
Select an input node and the parameters will come up as shown below:
OUTPUT TO
lets you decide where the output signal goes:
•
Output: Sets the signal output to unit’s output jacks (and phones jack)
•
FX SND: Sets the signal output to unit’s FX loop send jack
•
Chain B: For chain A only, which lets you connect chain A and B in series (see Effects Chain Types section on
•
None: For chain B only, in this case, chain B’s output node won’t work
OUT LEVEL
lets you adjust output level from Mute~-60dB~+20dB. Default is set to 0dB.
PAN
lets you adjust output signal stereo panning. The range is L50~Center~R50, default is set to Center.
Parallel
The chain A and B are fully parallel (won’t affect each other),
When you load an empty patch, the default effects chain
type is a special parallel state that only chain A is working.
Split-Mix
An input signal will be split into two and sent to both chain A
and B, then mixed into one and sent to one output:
Effects Chain Types
Ampero II Stomp supports various effects chain types:
Customizing Your Ampero II Stomp
14
DESIGN
INSPIRATION
Note: When you set
OUTPUT TO
to
FX SND
, the VOLUME knob will not work. In this case, use
OUTPUT LEVEL
to
control the output volume.
FX loop wiring diagram: blue stands for left channel (tip), and red stands for right channel (ring)
