17
Make sure that all parts are properly tightened each time the strength equipment is used. Replace any worn
parts immediately. Clean the strength equipment with a damp cloth and a mild, non-abrasive detergent;
do not
use solvents to clean the strength equipment
.
WEIGHT GUIDE LUBRICATION
Clean and lubricate the full length of each weight guide by wiping it with a soft cloth containing a lightweight
motor oil, 10W-40 or 10W-30 weight. Apply only a light coating over the entire length of each weight guide.
Do
not use TEFLON
®
or silicone-based lubricants.
MAINTENANCE
Note: For clarity, the
shrouds are not shown.
CABLE ADJUSTMENT
Woven cable, the type of cable used on the
strength equipment, can stretch slightly when it is
first used. If there is slack in the cable before resist-
ance is felt, the cable should be tightened.
Remove the M10 Thick Locknut (38) and the M10
x 86mm Bolt (84) from the U-brackets (16, 63), the
two Pulley Spacers (29), the Cable Trap (15), and
the Small Pulley (14).
Reattach the Small Pulley (14), the Cable Trap (15),
and the Pulley Spacers (29) to a lower hole in the
U-brackets (16, 63).
Make sure that the Cable Trap (15) is in the
proper position and that the Cable (36) and the
Small Pulley (14) move smoothly.
Do not overtighten the cables. If a cable tends
to slip off the pulleys often, it may have become
twisted. Remove the cable and reinstall it.
If a
cable needs to be replaced, see HOW TO CON-
TACT CUSTOMER CARE on the back cover of this
manual.
CABLE INSPECTION
Check the entire length of each cable by slowly per-
forming one repetition on the exercise equipment;
inspect the cable that is exposed on the exterior of
the strength equipment and the cable inside the
tower. Run your fingers along the cable, paying
close attention at the bends and attachment points.
Watch for the conditions shown at the right, which
may indicate a worn cable in need of replacement.
A
B
C
D
A. torn or split cable sheath
B. kinked or severely bent cable
C. curled or twisted sheath
D. stretched or thinning cable sheath
14
16
15
84
29
29
38
63
36
Summary of Contents for HF-FMXMTT.0
Page 20: ...20 NOTES...
Page 21: ...21 NOTES...